| | 6002.dat (Was Re: high-res sphere primitive with type 5 lines) [DAT]
|
|
(...) What's really, really fun is adding the new sphere to this part and spinning it around. Still needs a few type 5 lines around the notches on the bottom though... 0 FILE 6002.dat 0 part 6002 round Panel 6 x 6 x 9 with Spherous Top 0 by Mark (...) (22 years ago, 7-May-02, to lugnet.cad.dat.parts.primitives, lugnet.cad.dat.parts)
|
|
| | Re: Low res 1-8 sphere primitve
|
|
(...) FWIW I also like the new one better. (...) I agree. The type 5 lines from the edges belong in the file. See here for my convoluted and poorly written reasoning. (URL) (22 years ago, 7-May-02, to lugnet.cad.dat.parts.primitives)
|
|
| | Re: Low res 1-8 sphere primitve
|
|
(...) I have two comments. The first is that while I prefer my sphere tesselation to the standard one (and presumably you do also :-), a number of people prefer the standard one. I think that a vote of some sort might be in order before replacing (...) (22 years ago, 7-May-02, to lugnet.cad.dat.parts.primitives)
|
|
| | Re: high-res sphere primitive with type 5 lines
|
|
(...) Glad you like it. What's really fun is viewing a full sphere with the type 5 lines enabled, and then spinning it slowly. I had to do that a lot in order to verify that the lines were drawing correctly in LDView. Hopefully I'll have a release (...) (22 years ago, 7-May-02, to lugnet.cad.dat.parts.primitives)
|
|
| | Re: high-res sphere primitive with type 5 lines
|
|
(...) Very nice! It looks great -- I sat and stared at it for about five minutes. :) Did you want this posted on the Parts Tracker? Steve (22 years ago, 7-May-02, to lugnet.cad.dat.parts.primitives)
|