 | | Re: Updated Part 30117
|
|
(...) It is by design. I chose to ignore the line, the author should fix the problem. (He gets a warning (hm, should have been an error)) Likewise if a triangle has identical vertices I don't "fix" it to a line or a point. /Lars (23 years ago, 24-Oct-01, to lugnet.cad.dat.parts)
|
| |
| | Re: Subpart thingy.
|
|
(...) I'm afraid you'll have to make the subpart (primitive?) from scratch. The shortcut suggested above has an undesirable edge line (and also an always hidden surface). /Lars (23 years ago, 24-Oct-01, to lugnet.cad.dat.parts)
|
| |
| | Re: Infinite Horse
|
|
I started out on the horse parts long ago. Then two or three persons gave them a try. I could send my files, but I know there has been some improvements by others that won't be included if I send my versions. /Tore (...) (23 years ago, 23-Oct-01, to lugnet.cad.dat.parts)
|
| |
| | Re: 30283 Slope Brick 45 6 x 4 Double Inverted [DAT]
|
|
Here it is again. I made the suggested changes and ran L3P check on it. L3P didn't complain about anything so I'm assuming that's good : ) 0 Slope Brick 45 6 x 4 Double Inverted 0 Name: 30283.dat 0 Author: Jason S. Mantor 0 Derived from 4854.dat 0 (...) (23 years ago, 24-Oct-01, to lugnet.cad.dat.parts)
|
| |
| | Re: 30283 Slope Brick 45 6 x 4 Double Inverted
|
|
OK. I've added that line and I'm going to get L3P and check it. Thanks : ) Tore Eriksson <tore.eriksson@mbox3...wipnet.se> wrote in message news:GLoJID.3tK@lugnet.com... (...) discovered. (...) (23 years ago, 24-Oct-01, to lugnet.cad.dat.parts)
|
