 | | Re: New part, need a part number. [DAT]
|
|
Hmm, I see what you were refering to, I think. If I am not too mistaken, the original part I started with were missing these as well. Check it out again if you don't mind. :) Oh, how do I get a part number for this? (...) 0 Author : Ronald Scott (...) (24 years ago, 20-Feb-01, to lugnet.cad.dat.parts)
|
| |
| | Re: New part, need a part number.
|
|
Ronald: Looks ok, but at least one of the lines marking the change from horizontal to vertical is missing. Play well, Jacob (24 years ago, 20-Feb-01, to lugnet.cad.dat.parts)
|
| |
| | New part, need a part number. [DAT]
|
|
I made this part by editing 4854.dat Slope 45 4 x 4 Double Inverted. I needed this part to build a MLcad version of the TIE Fighter. I need a part number for this. Also, I am sure that it will need some error checking. 0 Author : Ronald Scott Moody (...) (24 years ago, 20-Feb-01, to lugnet.cad.dat.parts)
|
| |
| | 6578 Tyre 30.4 x 14 VR [DAT]
|
|
The file 6578s.dat in the following mpd file must be placed in the parts/s subdirectory 0 FILE 6578.mpd 0 Tyre 30.4 x 14 VR 0 Name: Untitled.dat 0 Author: Marc Klein 0 Unofficial Part 0 0 FILE 6578.dat 0 Tyre 30.4 x 14 VR 0 Name: 6578.dat 0 Author: (...) (24 years ago, 18-Feb-01, to lugnet.cad.dat.parts)
|
| |
| | NEW PART: 30414 Brick 1 x 4 with Studs On One Side [DAT]
|
|
0 Brick 1 x 4 with Studs On One Side 0 Name: 30414.dat 0 Author: Tore Eriksson 0 Un-Official LCad Part 1 16 20 4 0 1 0 0 0 -5 0 0 0 1 stud3.dat 1 16 0 4 0 1 0 0 0 -5 0 0 0 1 stud3.dat 1 16 -20 4 0 1 0 0 0 -5 0 0 0 1 stud3.dat 1 16 0 24 0 36 0 0 0 (...) (24 years ago, 17-Feb-01, to lugnet.cad.dat.parts)
|
