 | | Re: My first part
|
|
(...) Yes I did. Your comments are very helpful. I'll get started on them right away. (...) I tried that at first, but I kept getting some wierd overlap effects: some of the pattern would show, other parts wouldn't. I figured putting them at (...) (25 years ago, 13-Jul-99, to lugnet.cad.dat.parts)
|
| |
| | Re: new part: baseplate 32 x 32 raised with ramp
|
|
(...) I don't think it is necessary to round the edges. Besides, the first version did not have rounded edges on the pit. (...) Some lines that need fixing: When looking at it from above, the edges are angled, not straight. From the sides, the (...) (25 years ago, 13-Jul-99, to lugnet.cad.dat.parts)
|
| |
| | Re: My first part [DAT]
|
|
(...) The post seemed to come through fine. And your approach to making a part (at first blush) seems ok. I'll dig into the code in a minute. BTW, this is a good first part. The following comments are more at length than I normally make about new (...) (25 years ago, 13-Jul-99, to lugnet.cad.dat.parts)
|
| |
| | Re: 9v battery box small:almost complete version
|
|
(...) Ah. I don't usually pay much attention to the actual Dat file content. :) Jeff (25 years ago, 13-Jul-99, to lugnet.cad.dat.parts)
|
| |
| | My first part [DAT]
|
|
First off, I hope I'm doing this right; in terms both of posting and making a part. I need some feedback here: 0 Tile 2 x 2 Round with Yellow Submarine Radar Pattern 0 Name: 4150p?.dat 0 Author: Patrick Sayre-Little 0 Official LCad update ??-?? 0 2 (...) (25 years ago, 12-Jul-99, to lugnet.cad.dat.parts)
|
