 | | 32184 seems to be buggy [DAT]
|
|
I was trying to create the following dat, and found 32184 to be buggy Normally, there should be no yellow showing through the + shaped hole on the left side of the light blue shaped 32184. Sincerely Raphael P. Jacquot (I know, these are not kosher (...) (24 years ago, 22-Oct-00, to lugnet.cad.dat.parts)
|
| |
| | Re: Something I noticed
|
|
"Matt Schild" <phydeaux@sisna.com> wrote in message news:G2Kt8B.H5H@lugnet.com... (...) have (...) has (...) not (...) submit (...) I'm the author. Thanks for fixing this. Go ahead and send the fix to: partsref@home.com. -John Van (24 years ago, 21-Oct-00, to lugnet.cad.dat.parts)
|
| |
| | Re: rotation matrices
|
|
(...) No, the STUD3A has the correct diameter, 8LDU. The problem is the inside of the cross axle holes on the angle connectors. You'll note that a real life LEGO cross axle hole has a rounded internal cross section, which means that you can stick a (...) (24 years ago, 20-Oct-00, to lugnet.cad.dat.parts)
|
| |
| | Re: rotation matrices [DAT]
|
|
(...) Are you really sure? cause I looked at this file from Fredrik Glockner as an example about the studs to ad in the beginning and end of my curve and it says: 1 16 -90 40 0 0 5 0 -1 0 0 0 0 1 STUD3A.DAT 1 16 20 0 -90 0 0 1 1 0 0 0 5 0 (...) (24 years ago, 19-Oct-00, to lugnet.cad.dat.parts)
|
| |
| | Re: rotation matrices
|
|
(...) One (or more) of the three I mentioned. I'd be thinking more about angles, and building the segments, then putting the segments into place. Probably more of a manual process than an automatic one. Steve (24 years ago, 19-Oct-00, to lugnet.cad.dat.parts)
|
