| |
In lugnet.cad.dat.models.sets, Maico Arts writes:
> Hallo Ruediger
>
> I just looked at it and it looks quite nice! Just a question: why do you
> start with the 6x2 plates?
> About the brake dish: it is the one I also use for that kind of dishes. In
> the cyberslam sets there are a lot of this kind of dishes in several colors.
>
> Keep up the good work...
>
> greetings
> Maico Arts
Thanks for your comments!
Normally I try to create the DAT-Files in a way that enables everybody to
build it. This is, because I sometimes create models on my own (like my
RCX-cars I posted some days / weeks before "For TECHNIC-Fans") and may
re-build them months / years later.
So I usually start "bottom-up" and / or from "backside to frontside" (no
hidden parts).
With the 8219 it was my first attempt to "play" with the Rotation-Feature in
ML-CAD.
Exceptions are with very complex models like 5561. Since now I never used
MPDs, but when drawing a module (like the "motor" in the inner vehicle) I
draw it in the outside, mark all relevant pieces and then move it to its
destination. This is easy to create, but may be difficult to build
afterwards (hard to see the single parts).
Regards
Rüdiger
|
|
Message is in Reply To:
 | | Re: 8219 cart
|
| Hallo Ruediger "Ruediger Dietloff" <Ruediger_Dietloff@yahoo.de> schreef in bericht news:GLyw41.8H1@lugnet.com... (...) I just looked at it and it looks quite nice! Just a question: why do you start with the 6x2 plates? About the brake dish: it is (...) (23 years ago, 29-Oct-01, to lugnet.cad.dat.models.sets)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
