 | | New part, needs number: Minifig Kettle Helm [DAT]
|
|
A couple of notes about this piece: I don't know if "Kettle Helm" is even close to being correct, so name suggestions are welcome. I left out the notch at the back of the neck, because it was easier to do with primitives and didn't seem too (...) (24 years ago, 13-Sep-02, to lugnet.cad.dat.parts)
|
| |
| | Re: dragon parts
|
|
(...) Now they are finished. They can be found at: (URL) BB (24 years ago, 11-Sep-02, to lugnet.cad.dat.parts)
|
| |
| | Re: santa fe -poster- in progress
|
|
(...) I just tried this - it works very very well!! And it's not obtrusive at all. Thanks a million!! - Bob (24 years ago, 11-Sep-02, to lugnet.cad.dat.models, lugnet.trains)
|
| |
| | Re: santa fe -poster- in progress
|
|
Try this one: (URL) add 2 brackets 2x2, in gray of course :-) Even better if you mount it on top of the 1x2plate+corner plates. Good luck! Klaas H. Meijaard (...) (24 years ago, 11-Sep-02, to lugnet.cad.dat.models, lugnet.trains)
|
| |
| | Re: 1381 Vampire Crypt figs (and garlic tile)
|
|
(...) That is how I've coded up minifig heads in the past. Mentally divide face 45 degrees either side of the centre line and draw the region from +45 to -45 as a plane, then project that onto the four facets of the hexdecagon. Then if necessary, do (...) (24 years ago, 10-Sep-02, to lugnet.cad.dat.parts)
|
