Subject:
|
Re: Incomplete parts
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 3 Jan 2003 21:54:23 GMT
|
Viewed:
|
728 times
|
| |
|
|
In lugnet.cad, Niels Karsdorp writes:
> When making lots of parts BFC compliant I noticed
> that some parts are incomplete.
>
> 2463.dat : Inside faces are missing!
> 2464.dat : Inside faces are missing!
>
> How could these parts be certified? ;-)
Back in the days when these parts were released we had neither the Parts
Tracker nor the tools to view these parts critically. Acceptance was based on a
majority vote, and "no" votes did get over-ruled. Now, the certification
process is more rigourous (and thus potentially slower) - a single "no" vote is
sufficient to hold up the release.
> And another question:
> 2431p02.dat : Shouldn't this part be grooved?
Yes
> 2431p12.dat : Shouldn't this part be grooved?
Not sure - but probably
> 2431p51.dat : Shouldn't this part be grooved?
Yes
>
> Niels
Chris
|
|
Message is in Reply To:
 | | Incomplete parts
|
| When making lots of parts BFC compliant I noticed that some parts are incomplete. 2463.dat : Inside faces are missing! 2464.dat : Inside faces are missing! How could these parts be certified? ;-) And another question: 2431p02.dat : Shouldn't this (...) (22 years ago, 3-Jan-03, to lugnet.cad)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
