Subject:
|
Panning in L3Lab ?
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Wed, 11 Dec 2002 16:06:39 GMT
|
Viewed:
|
427 times
|
| |
|
|
Is it possible to pan a model in L3Lab?
It often happens that a significant part of the
model is not visible, because it is below the
screen and at the top is a large blank area.
Niels
|
|
Message has 1 Reply:
 | | Re: Panning in L3Lab ?
|
| (...) Sorry, no, the center of the model is always located at two thirds of the height. I can't really remember why, perhaps because LDraw does so per default? When I'm done with L3P I'll give L3Lab an overhaul, and one of the many requests has been (...) (22 years ago, 11-Dec-02, to lugnet.cad)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
