Subject:
|
Re: Newbie Question
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 27 Nov 2001 17:19:46 GMT
|
Viewed:
|
718 times
|
| |
|
|
In lugnet.cad, Slavick Mikhaylov writes:
> Ok Im a newbie to CAD but I can't find the answer anywhere else. Using the
> minifig parts found in MLCAD I couldn't put the hands to rotate to fit the
> arms. Anyone know what I may be possibly doing wrong?
Two suggestions:
1. Peek in the minifig shortcut files (er, uh, those are parts 979 and 980).
Those have the hands in the right position/angle.
2. Search lugnet for previous discussion on this topic. One decent
discussion can be found at <http://news.lugnet.com/cad/dev/?n=4350&t=i&v=a>.
Another is <http://news.lugnet.com/cad/dev/?n=6205&t=i&v=a>.
I thought of a third suggestion while I was writing this:
3. Use the minifig modeller tool in LDraw Add-On to setup your minifigs.
HTH,
Steve
|
|
Message has 1 Reply:
 | | Re: Newbie Question
|
| (...) I thought of using the minifig modeler in the Ldraw Addon scince I couldn't find a way with the other two suggestion and saw that it's down. Is there any other place I can download it from? (23 years ago, 17-Dec-01, to lugnet.cad)
|
Message is in Reply To:
| | Newbie Question
|
| Ok Im a newbie to CAD but I can't find the answer anywhere else. Using the minifig parts found in MLCAD I couldn't put the hands to rotate to fit the arms. Anyone know what I may be possibly doing wrong? (23 years ago, 27-Nov-01, to lugnet.cad)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
