 | | Re: Reiterate: How to make a squish matrix?
|
| that shouldn't be too hard either. just operate the matrix on the points alone. if your cilinder has it's axle around the Y axle. L is the length of the cilinder and if it starts at 0 0 0 you could use (1-y/L) 0 0 0 1 0 0 0 (1-y/L) this would turn (...) (24 years ago, 25-Apr-01, to lugnet.cad, lugnet.cad.ray)
| | | | | Re: Reiterate: How to make a squish matrix?
|
| (...) Yes, but you cannot put (1-y/L) into a transformation matrix. It is a *function* that changes for each 3D point. The purpose of a tranformation matrix is to precalculate a matrix of *numbers* that gets multiplied by all the points of the (...) (24 years ago, 25-Apr-01, to lugnet.cad, lugnet.cad.ray)
| |
