Subject:
|
Circular Primitives
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sat, 7 Apr 2001 17:39:50 GMT
|
Viewed:
|
377 times
|
| |
|
|
hi,
I have been using mlcad for just over two months, so i'm not fully clued up
yet. I need to make a part which is a wide diameter cylinder. I have managed
to do so by creating a 24 sided polygon and extruding it. However due to its
size, the straight sides are plainly visible. Is there any way to produce a
'pure' circle and then extrude it, or to create a cylinder in one go?
thanks
John
|
|
Message has 1 Reply:
 | | Re: Circular Primitives
|
| (...) You can try using the 48-segment primitives in the ldraw/p/48 directory. The cylinder primitive is 1-4cyli.dat. The easiest way to code this up is in a text editor, but you should be able to do it through MLCAD as well. The code to make a (...) (23 years ago, 9-Apr-01, to lugnet.cad)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
