 | | Re: Has this piece been made yet? —Steve Bliss
|
| | | (...) Nope, not yet. Steve (23 years ago, 18-Jan-01, to lugnet.cad)
|
| | | |
| | | | | Re: Has this piece been made yet? —Chris Dee
|
| | | | (...) I was tempted to take a look at this last night - and I've made a start (I know, I know, I should be finishing the minifig hair ! - but I've made further progress on that as well in the past week). Work on the exhaust may still get stalled if (...) (23 years ago, 19-Jan-01, to lugnet.cad)
|
| | | | |
| | | | | | Re: Has this piece been made yet? —Daniel Crichton
|
| | | | | "Chris Dee" <chris_w_dee@hotmail.com> wrote in message news:G7EHDL.Lsz@lugnet.com... (...) further (...) Any rough DATs to look at yet? <dribble> Dan (23 years ago, 19-Jan-01, to lugnet.cad)
|
| | | | | |
| | | | | | | Re: Has this piece been made yet? —Chris Dee
|
| | | | | | (...) What exists at the moment it the primitive-based sections - straight cylinders, discs, etc - so it not even a joined-up part as yet. I am happy that these sections are in the correct positions relative to each other. Please be patient. (...) (23 years ago, 19-Jan-01, to lugnet.cad)
|
| | | | | | |
| | | | | | | | Re: Has this piece been made yet? —Steve Bliss
|
| | | | | | (...) Hmm. For usability, I'd put the origin between the two rods that hold the piece in place. Vertically, I'd position it so the topmost bit of the straight, vertical rods is at Y=0. (...) Yes. (...) I don't know, but I'll ask. Steve (23 years ago, 19-Jan-01, to lugnet.cad)
|
| | | | | | |
| | | | | | Re: Has this piece been made yet? —Jaco van der Molen
|
| | | | | Thank you in advance Chris! Greetingz... Sjaacko (...) tricky. (...) (23 years ago, 24-Jan-01, to lugnet.cad)
|
| | | | | |
| | | | | | Re: Has this piece been made yet? —Chris Dee
|
| | | | (...) tricky. (...) This part has now been completed and posted as (URL) Chris (23 years ago, 4-Feb-01, to lugnet.cad)
|
| | | | |
