Subject:
|
Re: Has this piece been made yet?
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Thu, 20 Jan 2000 10:24:44 GMT
|
Viewed:
|
571 times
|
| |
|
|
Daniel Crichton wrote:
>
> "Chris Czajka" <kgbopertv@aol.com> wrote in message
> news:G7CFEz.4sn@lugnet.com...
> > Just wanted to check in real quick and see if this piece has been made • yet.
> > I dont know what to officially call the piece, but its the piece used in • the
> > Tie Fighter and Sith Infiltrator set. Its the piece That is used to • connect
> > the wings to the body of each craft. I hope you all know which piece I am
> > referring to. If it has been made, where can I get it. And if not, are
> > there any plans by anyone to make it yet?
>
> Check part 30000.dat, "Brick 2 x 2 with Pins and Axlehole". It's a 2 x 2
> brick with a pin on each of 2 opposite sides and a technic axle hole
> vertically through the centre.
>
> Dan
I think I know the part that chris is talking about and 30000 isnt it.
I think he is refering to the piece that has the 4 slopes
|
|
Message has 1 Reply:
 | | Re: Has this piece been made yet?
|
| "Jonathan Wilson" <jonwil@tpgi.com.au> wrote in message news:3886E26C.9D0A71....com.au... (...) Ah, 30373, "Slope Brick 65 6 x 6 x 2 Quad Inverted with Cutouts". A mock-up was posted to cad.dat long ago by Steve Bliss in (URL) . I've got it here on (...) (24 years ago, 18-Jan-01, to lugnet.cad)
|
Message is in Reply To:
| | Re: Has this piece been made yet?
|
| "Chris Czajka" <kgbopertv@aol.com> wrote in message news:G7CFEz.4sn@lugnet.com... (...) yet. (...) the (...) connect (...) Check part 30000.dat, "Brick 2 x 2 with Pins and Axlehole". It's a 2 x 2 brick with a pin on each of 2 opposite sides and a (...) (24 years ago, 18-Jan-01, to lugnet.cad)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
