Subject:
|
Tubing
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 15 Sep 2000 03:38:50 GMT
|
Viewed:
|
515 times
|
| |
![Post a public reply to this message](/news/icon-reply.gif) | |
Can anyone tell me how to generate in LEdit or POV-Ray the tubing found
in the Hydronauts set #6150?
Travis Dickinson
|
|
Message has 2 Replies: ![](/news/x.gif) | | Re: Tubing
|
| (...) This one is somewhat tricky. Not only is the tube curved -- it is also somewhat "fatter" in the ends, because it is put onto some thin cylindrical elements. If you overlook the "fat" ends, you can use a tool I've made to model a curved hose in (...) (24 years ago, 15-Sep-00, to lugnet.cad)
| ![](/news/x.gif) | | Re: Tubing
|
| Probably off-topic, but I just wanted to tell that there is an LDS command called PIPE. You can build a static tubing by entering a series of "discs", or rather 4-4edges. LDS then fills the space between them a thus makes a pipe. Just a nonsense (...) (24 years ago, 16-Sep-00, to lugnet.cad)
|
7 Messages in This Thread: ![You are here](/news/here.gif) ![](/news/246.gif) ![Re: Tubing -Fredrik Glöckner (15-Sep-00 to lugnet.cad)](/news/x.gif) ![](/news/246.gif) ![Re: Tubing -Fredrik Glöckner (15-Sep-00 to lugnet.cad)](/news/x.gif)
![](/news/x.gif) ![](/news/28.gif) ![](/news/x.gif) ![](/news/68.gif) ![Re: Tubing -Travis Dickinson (16-Sep-00 to lugnet.cad)](/news/x.gif) ![](/news/46.gif) ![Ignore previous message - See inside -Travis Dickinson (17-Sep-00 to lugnet.cad)](/news/x.gif) ![](/news/46.gif) ![Re: Ignore previous message - See inside -Fredrik Glöckner (17-Sep-00 to lugnet.cad)](/news/x.gif)
![](/news/x.gif) ![](/news/68.gif) ![Re: Tubing -Tore Eriksson (16-Sep-00 to lugnet.cad)](/news/x.gif)
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|