Subject:
|
Re: *** MLCad V1.9 Release 4 ***
|
Newsgroups:
|
lugnet.cad, lugnet.cad.mlcad
|
Date:
|
Fri, 30 Jun 2000 13:07:38 GMT
|
Viewed:
|
1859 times
|
| |
|
|
In lugnet.cad, Michael Lachmann wrote:
> Keyboard command I launches the part window to allow you to enter the part
> number. So far I know LEdit expects the part number following the I and then
> creates a new part .... this is what MLCad does as well.
> The P command is used to change a currently selected part to a different
> one.
In LEdit, the I keystroke inserts a duplicate of the current part/line. To
insert a different type of part, you have to key IP<number><Enter>.
Steve
|
|
Message is in Reply To:
 | | Re: *** MLCad V1.9 Release 4 ***
|
| Keyboard command I launches the part window to allow you to enter the part number. So far I know LEdit expects the part number following the I and then creates a new part .... this is what MLCad does as well. The P command is used to change a (...) (24 years ago, 30-Jun-00, to lugnet.cad, lugnet.cad.mlcad)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
