Subject:
|
Re: LDraw Help
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 3 Sep 1999 21:25:28 GMT
|
Viewed:
|
457 times
|
| |
|
|
In lugnet.cad, Greg Majewski writes:
> Hello,
> I was planning on finally downloading LDraw this weekend and started the
> process a few minutes ago. I followed the directions from ldraw.org very
> closely, but when the directions said to go into "Run," I typed in
> c:\ldraw.exe-y, but there was an error and it said it could not open the file
> or something to that extent. Any and all help appreciated. Thank you,
Did you put a space between ldraw.exe and -y? If not, you probably should.
--Bram
|
|
Message has 1 Reply:
 | | Re: LDraw Help
|
| (...) Yes, I tried lots of variations on that, as well as capitalizations. ~Greg (25 years ago, 4-Sep-99, to lugnet.cad)
|
Message is in Reply To:
| | LDraw Help
|
| Hello, I was planning on finally downloading LDraw this weekend and started the process a few minutes ago. I followed the directions from ldraw.org very closely, but when the directions said to go into "Run," I typed in c:\ldraw.exe-y, but there was (...) (25 years ago, 3-Sep-99, to lugnet.cad)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
