Subject:
|
Re: LPub 4.0.0.0.4 BOM issue with BUFEXCHG
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 9 Feb 2010 00:34:26 GMT
|
Viewed:
|
13366 times
|
| |
|
|
In lugnet.cad, William Howard wrote:
> See below
>
> I would expect the BOM to contain 6 different coloured 2x3 plates, but the last
> two (added after the BOM END) are ignored - in fact with a very big file
> everything after the BOM END is ignored (almost as if the BOM END isn't seen)
>
> Also, I cannot work out how to display an alternative part for the cable
> sub-part in step 2 in the PLI (a simple red 2x2 plate would suffice as an
> example) and it would also need to show in the BOM
0 !LPUB PLI BEGIN SUB 3021.DAT 1
This one was broken too.
Kevin
|
|
Message is in Reply To:
 | | LPub 4.0.0.0.4 BOM issue with BUFEXCHG [DAT]
|
| See below I would expect the BOM to contain 6 different coloured 2x3 plates, but the last two (added after the BOM END) are ignored - in fact with a very big file everything after the BOM END is ignored (almost as if the BOM END isn't seen) Also, I (...) (15 years ago, 7-Feb-10, to lugnet.cad)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
