Subject:
|
Re: problem: only one part visible
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Thu, 2 Dec 2004 13:39:17 GMT
|
Viewed:
|
731 times
|
| |
|
|
In lugnet.cad, Niels Bugge wrote:
> In lugnet.cad, Sonnich Jensen wrote:
> > Hi!
> >
> > My problem is, that when I move some partys by hand, it hides most of the other
> > bricks, which makes it hard to locate them.
> > Why is this?
> >
> > I still have huge problems with rotating parts in odd angles, it there a way, to
> > set a "direct" angle?
> > E.g. a wall to 53 degress, or a vertical plate to be rotated 45 degrees, and
> > turned "backwards" 15 degrees?
> >
> >
> > is there a way to snap parts to other parts, which already have an odd
> > location/angle?
>
> Hmm it could sound like you're using LDD with those problems, but it's hard to
> give relevant advice if you don't tell us what program you use...
MLCad (windows version)
and:
Is there a way to grap a corner, and turn/pull a brick a bit?
S
|
|
Message is in Reply To:
 | | Re: problem: only one part visible
|
| (...) Hmm it could sound like you're using LDD with those problems, but it's hard to give relevant advice if you don't tell us what program you use... -NB (20 years ago, 2-Dec-04, to lugnet.cad)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
