Subject:
|
Re: Multicolor identical lines in a datfile?
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sat, 31 Jan 2004 17:47:02 GMT
|
Viewed:
|
2109 times
|
| |
|
|
In lugnet.cad, Niels Karsdorp wrote:
> Two parts I've created are combinations of pieces in two colors.
> Part x277 (Fabuland Wheelbarrow Wheels) contains a red axle and two plain wheels
> (yellow as only known color).
> Part x323 (Light Bulb for Electric Light Brick 2 x 4) contains a glass bulb
> with metal side tips.
>
> At the place where the pieces in the two colors are adjecant, it can cause
> duplicate lines (like the place where the red axle is attached to the wheels,
> there is a red 4-4edge of the axle and a plain 4-4edge of the wheel at the same
> coordinates.)
>
> Is this a problem?
> Should it be avoided?
> Should different subparts be used?
It wouldn't hurt to put the component parts in different ~part files. Otherwise, if
you leave it all as one file, I wouldn't put both of the edges in.
Steve
|
|
Message is in Reply To:
 | | Multicolor identical lines in a datfile?
|
| Two parts I've created are combinations of pieces in two colors. Part x277 (Fabuland Wheelbarrow Wheels) contains a red axle and two plain wheels (yellow as only known color). Part x323 (Light Bulb for Electric Light Brick 2 x 4) contains a glass (...) (23 years ago, 23-Jan-04, to lugnet.cad)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
