 | | Re: Looking for broken pneumatics
|
|
(...) For parts like that, you don't need to model the inside of the part. That is not required for it to be submitable to the LDraw parts library. Of course, if you _want_to_, it adds to the quality of the parts if the internals is modeled! Fredrik (25 years ago, 1-Feb-00, to lugnet.technic, lugnet.cad.dev)
|
| |
| | Re: Best hardware for MLCad?
|
|
(...) Ok here are the real minimum hardware requirements for MLCad (V1.7 Release 2): - Any computer running with Windows 95/98 or NT - Harddisk mainly depends on the operating system plus arround 100 MB (for dat files and swap-space) - Graphic card (...) (25 years ago, 1-Feb-00, to lugnet.cad.mlcad)
|
| |
| | Re: Best hardware for MLCad?
|
|
It will probably work but you will HATE it at that speed. (25 years ago, 1-Feb-00, to lugnet.cad.mlcad)
|
| |
| | Re: Best hardware for MLCad?
|
|
(...) As I stated before, the computer is a 486 66MHz. It has 8MB of RAM. Barely enough to run Win95. As far as video and graphics cards, I don't have a clue anymore. I would like to think that I could use it for MLCad, otherwise it's probably (...) (25 years ago, 31-Jan-00, to lugnet.cad.mlcad)
|
| |
| | Re: Suggestion for MLCad Plug-Ins
|
|
Steve Bliss skrev i meddelandet ... (...) We'll think about it later... (...) When a (...) Sounds like a good idea - I'll test it when Real Life permits. Will LDAO also allow drag *from* LDAO to xxx? By using the same protocol you could use LDAO (...) (25 years ago, 31-Jan-00, to lugnet.cad.mlcad, lugnet.cad.dev)
|
