To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cadOpen lugnet.cad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / *47556 (-10)
  Re: LPub not generating torus in output images
 
(...) Well, here goes: (URL) (13 years ago, 22-Mar-12, to lugnet.cad)
 
  Re: LPub not generating torus in output images
 
(...) The format is still the same and any software should render parts that conform to the original 0.1 format just as well as anything more recent. To do otherwise is a failure. Tim (13 years ago, 22-Mar-12, to lugnet.cad)
 
  Re: LPub not generating torus in output images
 
(...) Point taken. I'll give it a shot. The problem is that I've written somewhere upwards of 1,100 parts, and although these do indeed conform to the pre-legalese LDraw format, they don't have the elaborate file header now present in official (...) (13 years ago, 22-Mar-12, to lugnet.cad)
 
  Re: LPub not generating torus in output images
 
(...) There's plenty of people that work with LDraw outside the official library. So long as your parts are valid LDraw Format a problem with renderers is worth mentioning where others will actually see it. Or in short you can ask somewhere where an (...) (13 years ago, 22-Mar-12, to lugnet.cad)
 
  Re: LPub not generating torus in output images
 
(...) Hmm... I'm a bit apprehensive about the reception I'll get there. It's no secret that I'm not exactly working with canonical material... (13 years ago, 22-Mar-12, to lugnet.cad)
 
  Re: LPub not generating torus in output images
 
(...) Perhaps you should report this error in the LDraw forums. I'm not sure Travis still checks here (noting the source of the error). Tim (13 years ago, 22-Mar-12, to lugnet.cad)
 
  Re: LPub not generating torus in output images
 
(...) because it loses some of the basic functionality of the earlier version, and it's completely hobbled by errors that the older versions were able to accommodate without even blinking. LPub version 4.0.0.11 is brought to a standstill by the (...) (13 years ago, 22-Mar-12, to lugnet.cad)
 
  Re: I quit.
 
--snip-- (...) Hi Tore, I'm very sorry to hear about your health problems and wish you great luck and fortitude in recovering your health as best you can. And I can fully understand that adding additional stress is not good for this. Better not to (...) (13 years ago, 9-Mar-12, to lugnet.cad)
 
  Re: I quit.
 
Hi Tory, Sorry to hear this, but I think we all can understand. I personally thank you for all your effort to the LDraw community and thank you for years of contact. We'll keep in touch otherwise. Best regards, Jaco (13 years ago, 9-Mar-12, to lugnet.cad)
 
  Re: I quit.
 
(...) Hi Tore, Sorry to hear that your leaving. But if you think this is the best way, i'll understand. Hope your health won't decline too fast. I wish you all the best in what you like to do in the future. Regards and take care. Ludo (13 years ago, 8-Mar-12, to lugnet.cad)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR