To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cadOpen lugnet.cad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / *47552 (-5)
  Re: LPub not generating torus in output images
 
(...) Hmm... I'm a bit apprehensive about the reception I'll get there. It's no secret that I'm not exactly working with canonical material... (13 years ago, 22-Mar-12, to lugnet.cad)
 
  Re: LPub not generating torus in output images
 
(...) Perhaps you should report this error in the LDraw forums. I'm not sure Travis still checks here (noting the source of the error). Tim (13 years ago, 22-Mar-12, to lugnet.cad)
 
  Re: LPub not generating torus in output images
 
(...) because it loses some of the basic functionality of the earlier version, and it's completely hobbled by errors that the older versions were able to accommodate without even blinking. LPub version 4.0.0.11 is brought to a standstill by the (...) (13 years ago, 22-Mar-12, to lugnet.cad)
 
  Re: I quit.
 
--snip-- (...) Hi Tore, I'm very sorry to hear about your health problems and wish you great luck and fortitude in recovering your health as best you can. And I can fully understand that adding additional stress is not good for this. Better not to (...) (13 years ago, 9-Mar-12, to lugnet.cad)
 
  Re: I quit.
 
Hi Tory, Sorry to hear this, but I think we all can understand. I personally thank you for all your effort to the LDraw community and thank you for years of contact. We'll keep in touch otherwise. Best regards, Jaco (13 years ago, 9-Mar-12, to lugnet.cad)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR