To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cadOpen lugnet.cad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / *47301 (-5)
  Re: Getting Started LDraw All-In-One-Installer 2010-03 Update Now Available
 
(...) Yes, LDView can be used via command-line. This is how LPub uses it. The reference is in the help file that comes with LDView. I think the Travis put some stuff in there to mimic L3P commands as well. -Orion (13 years ago, 27-Jun-11, to lugnet.cad.dev.org.ldraw)
 
  Re: Getting Started LDraw All-In-One-Installer 2010-03 Update Now Available
 
(...) OK, I'm going to have to work around this for a while. My problem is that I support a large community of users, with a package that uses LDraw to construct 3D data charts as an add-on to Microsoft Excel. Built into the nmacro code is the full (...) (13 years ago, 27-Jun-11, to lugnet.cad.dev.org.ldraw)
 
  Re: Lego Architecture
 
(...) Yes, I have one (URL) (13 years ago, 27-Jun-11, to lugnet.cad)
 
  Re: Lego Architecture
 
(...) There might be some on my repository. But I am not sure. (URL) (13 years ago, 27-Jun-11, to lugnet.cad)
 
  Re: Getting Started LDraw All-In-One-Installer 2010-03 Update Now Available
 
(...) Thx for pointing. I'll check that. (...) Orion and Tim are correct. Conversion should be done via LDView. As long as there is no user friendly interface with L3PAO buggy as it is today: (URL) not going to include L3P. w. (13 years ago, 27-Jun-11, to lugnet.cad.dev.org.ldraw)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR