 | | Re: 3D matrix math question
|
|
(...) Hmmm... Though I can't quite pin it down I have a suspicion that this has something to do with the spatial reduction cause by projection. What projection matrix are you using? Would a simple solution just be to move the conditional points (...) (16 years ago, 14-Dec-08, to lugnet.cad.dev, FTX)
|
| |
| | Re: 3D matrix math question
|
|
(...) I am not the best in 3D, but if something outside the view frustum, you do not need to draw that. If you have the special case that only parts of what you should draw are outside the view frustum, I would go to calculate that values for a (...) (16 years ago, 14-Dec-08, to lugnet.cad.dev, FTX)
|
| |
| | Re: 3D matrix math question
|
|
(...) Actually, the projected points are all that I am checking, and that's how it's supposed to work. (...) No. The way that conditional lines work is that if the two control points lie on the same side of the conditional line on the screen (in (...) (16 years ago, 14-Dec-08, to lugnet.cad.dev, FTX)
|
| |
| | Re: 3D matrix math question
|
|
(...) If I understand correctly you shouldn't be checking on the projection, only on the full 3D transformed points. That means you should check after stage 2.5. You'll need the Z value to work out which side things lie on. Tim (16 years ago, 14-Dec-08, to lugnet.cad.dev, FTX)
|
| |
| | 3D matrix math question
|
|
(...) I think I need help. I thought I was using gluProject for the conditional calculations, but discovered that I'm not. I multiple the projection matrix by the model-view matrix to get my transformation matrix, then run the points through that to (...) (16 years ago, 14-Dec-08, to lugnet.cad.dev, FTX)
|
| |
| | Re: Conditional Ring primitive?
|
|
(...) OK, I'll go on evaluating cedge interest when you have fixed this issue. (...) Could be workable indeed. Philo (16 years ago, 13-Dec-08, to lugnet.cad)
|
| |
| | Re: Colinear Vertices
|
|
(...) Of course I start counts from zero ;o) (...) OK! My setup seems to work anyway... Philo (16 years ago, 13-Dec-08, to lugnet.cad)
|
| |
| | Re: Conditional Ring primitive?
|
|
(...) Looks like you found another LDView bug ;-). Zoom out and it works fine. It only doesn't work when the control points are clipped by the edge of the window. I'll have to figure out a way to fix that. (...) It's difficult, but by using polling (...) (16 years ago, 13-Dec-08, to lugnet.cad)
|
| |
| | Re: Colinear Vertices
|
|
(...) Hopefully you have primitive substitution set to two (second notch), since 1 provides 8-sided circular primitives. As for separating the stud logo from the primitive substitution, the logo is an implicit part of the substituted stud. It's not (...) (16 years ago, 13-Dec-08, to lugnet.cad)
|
| |
| | Re: BlueBrick
|
|
(...) Hi Michael, I've just released a new version of BlueBrick that fix the problem for the 4.5V and 12V rails. But you will need to upload some unofficial LDraw parts from the LDRAW.org part tracker, especially the new shortcuts created by Philo (...) (16 years ago, 13-Dec-08, to lugnet.cad, FTX)
|
