 | | Re: LSynth electric cable cross section oriention problem
|
|
(...) Leo, In case you didn't get this far, I solved the above problem and can now control twist all through a cable segment from start point to end point. I calculate the up vector for the start of segment, and the up vector for the end of segment. (...) (18 years ago, 26-Nov-06, to lugnet.cad.dev)
|
| |
| | LDAO problem
|
|
i guess this would be the correct spot for the message. i have a install problem with LDAO. i install it, and when i stat it i get error 76 , path not found. (18 years ago, 26-Nov-06, to lugnet.cad.dev)
|
| |
| | Tyre 30.4x14 VR
|
|
Hi all, Anyone having a mocup from the following tyre? (...) Any help with a mocup is apreciated. Regards, Ludo (18 years ago, 25-Nov-06, to lugnet.cad.dat.parts, FTX)
|
| |
| | Tyre 30.4x14
|
|
Hi all, Anyone having a mocup from the following tyre? (URL) I noticed the request for it abouth 4 years ago, and it is still not apearing on the LDRAW site - unofficial parts. Any help with a mocup is apreciated. Regards, Ludo (18 years ago, 25-Nov-06, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: DAT file for 4531-9V Switches
|
|
(...) on LDraw's parts tracker searching for 4531. Thanks in advance for any (...) tracking it down. Hi, Take here a look for a mocup of the 9V RC points (100% plastic) by Thomas Burger: (URL) They are build after my mocup for the 9V point (with (...) (18 years ago, 25-Nov-06, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: Lego factory sets / building instructions
|
|
(...) Hi Ville, Unfortunately, there's no simple way to get the typical LEGO instructions experience with Factory. Often LDD's automatic instruction steps aren't well organized and sometimes impossible to follow. It's better if the model author (...) (18 years ago, 25-Nov-06, to lugnet.trains, lugnet.cad.ldd)
|
| |
| | Re: LSynth electric cable cross section oriention problem
|
|
I've got up/side/front vector stuff working now, so that I can control the orientation of cross sections of electrical cables at the start of a segment defined by two constraints. My issue now is that I don't know how to force the twist so that the (...) (18 years ago, 24-Nov-06, to lugnet.cad.dev)
|
| |
| | Re: bend thingie creator.
|
|
(...) Let me check my archive of LDraw related programs and if I have it I'll email it to you. -Orion (18 years ago, 24-Nov-06, to lugnet.cad.dev)
|
| |
| | LSynth electric cable cross section oriention problem
|
|
Hi, I've got a reworked version of LSynth with a major problem... I cannot figure out how to control the twist of the cross section. I use bezier curve to created the nicely curved set of points, and compress it by tossing out points until the angle (...) (18 years ago, 24-Nov-06, to lugnet.cad.dev)
|
| |
| | Re: bend thingie creator.
|
|
(...) Koen, I tried to email you using your address, and I tried to download your bendie thingy creator. It is gone. Does anyone have a copy of this so I can play with it? Kevin (18 years ago, 24-Nov-06, to lugnet.cad.dev)
|
