 | | Re: Part building advice - too many triangles/quads?
|
|
Thanks everyone for the advice. After posting last night I went ahead and changed the hat puff to a 1/8 segment and called it s/6898s18.dat. Any conditional lines falling along the x, z, x+z (diagonal), or x-z axes were moved into the main file to (...) (20 years ago, 26-Nov-04, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: Part building advice - too many triangles/quads?
|
|
(...) LDraw Design Pad can do this. You can find it at (URL) (20 years ago, 26-Nov-04, to lugnet.cad.dat.parts)
|
| |
| | Fixed LGEO parts
|
|
Lutz Uhlmann (Chaot!X) is the author of almost a thousand LGEO parts, which are very nice looking (rounded edges) POV versions of LDraw parts. The LGEO parts, however, haven't been updated since September 23, 1999. During the last couple of years I (...) (20 years ago, 26-Nov-04, to lugnet.cad.ray, lugnet.cad)
|
| |
| | Re: Problem creating .pov using LGEO parts in L3PAdd-on
|
|
Thanks (...) Orion Thanks for the offer If you would like to sendme an email I can send it to I will do so. my email - mcjmsmith at sympatico.ca - (20 years ago, 26-Nov-04, to lugnet.cad.ray)
|
| |
| | Re: Part building advice - too many triangles/quads?
|
|
(...) I think the filesize:quality ratio is good. I notice that almost everything is coded to 4 decimal places. Except when (and maybe not even then) a surface joins to a circular primitive, 3 DPs should be sufficient in parts (0.0001 LDu < 0.00002 (...) (20 years ago, 25-Nov-04, to lugnet.cad.dat.parts, FTX)
|
