 | | Creating 47457.dat 2x2x2/3 Sloped&Rounded
|
|
(...) I'm not a kid any more (I'm 37) and am quite new in the community. One of my deep desire is to contribute to the community by starting part authoring. So if you plan to write a tutorial (for kids it is perfect), easy to follow, about your (...) (20 years ago, 20-Sep-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Creating 47457.dat 2x2x2/3 Sloped&Rounded
|
|
(...) My goodness, that was one massive scary part! I'm going to look that up and see how many lines it took! I would have chosen the click rotation joint. I figured I needed a very simple part to warm up. Talking about "not too far off", should I (...) (20 years ago, 20-Sep-04, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: LPub mask generation
|
|
(...) Hi Travis, I've downloaded LDview, and gotten libpng and zlib built under C++ Builder. What classes do you have for reading and writing PNG files based on libpng. I'd like to give them a look. Thanks, Kevin (20 years ago, 20-Sep-04, to lugnet.cad.dev)
|
| |
| | Re: Creating 47457.dat 2x2x2/3 Sloped&Rounded
|
|
(...) Ah, conditional lines! I didn't even think about those. Thanks! I'll look into it and see if I can figure it out. I'll also learn how to use Show All Edge Lines. By the way, the part is common to 3 of the large good guys of Knights Kingdom. I (...) (20 years ago, 20-Sep-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Creating 47457.dat 2x2x2/3 Sloped&Rounded
|
|
Congratulations on initial completion of your first part. (...) I don't have this part (at least I don't think), so I can't comment on the accuracy of the geometry. However, I can comment on three things I saw. First, it looks like you used color 16 (...) (20 years ago, 19-Sep-04, to lugnet.cad.dat.parts)
|
