| | Re: Hold on primitives by pneaster
|
|
Paul Easter <pneaster@knoxy.nospm.net> schrieb im Newsbeitrag news:HGBwv1.22HB@lugnet.com... (...) For example sin(22.5°)= 0.3827 for R=1 (in edge.dat) 15*sin(22.5°)= 5.7403 for correct point 15* (0.3827) = 5.7405 for stretching the edge.dat A (...) (21 years ago, 11-Jun-03, to lugnet.cad)
|
|
| | Re: Hold on primitives by pneaster
|
|
(...) It's me... (...) I have had a few emails with the Parts Tracker admin's lately to discuss the creation of primitives. I was INCORRECTLY using the rounding method that rounded only the final results. Like this; round( r* sin( Angle ), 4). The (...) (21 years ago, 11-Jun-03, to lugnet.cad)
|
|
| | Re: POV in Part
|
|
(...) Since L3P already supports the LGEO part library, is it possible to just add new LGEO parts and have L3P automatically use them? The only problem I see with this is that the .tab files in the LGEO library are binary files, but the format of (...) (21 years ago, 11-Jun-03, to lugnet.cad.dat.parts, lugnet.admin.suggestions)
|
|
| | Re: POV in Part
|
|
(...) I'm not too keen on this idea. While POV-Ray is a nice tool and freeware, I'd like to avoid dedicating ourselves to one tool, not to mention the size increase on all the files. If all you want is nice looking parts for POV try a combo of (...) (21 years ago, 11-Jun-03, to lugnet.cad.dat.parts, FTX)
|
|
| | Re: POV in Part
|
|
Steve Bliss <steve.bliss@earthlink.net> schrieb im Newsbeitrag news:70ncevsg5a3ulag...4ax.com... (...) I think we could, but where can I find the POV-code expressions? CU Bernd (21 years ago, 11-Jun-03, to lugnet.cad.dat.parts)
|