 | | Re: Part Measurements and Authoring
|
|
(...) If the region of the part interfaces with an existing part then I base it upon that. Although, feel free to challenge existing parts if they are incorrect. Otherwise I do use a micrometer or steel rule (Imperial dimensions - using 1/64 = (...) (22 years ago, 5-Mar-03, to lugnet.cad.dev)
|
| |
| | Re: Question about primitives
|
|
(...) Yes. Run "l3p -pp" to see which primitives L3P supports. (URL) (22 years ago, 5-Mar-03, to lugnet.cad.ray)
|
| |
| | looking for information on a particular old MOC
|
|
From memory, it was done by one Joseph Gonzalis and was an alternate model of the 6973 Deep Freeze Defender. I seem to rember building instructions for it somewhere but now they are gone. Does anyone have building instructions or a .dat file for (...) (22 years ago, 5-Mar-03, to lugnet.cad, lugnet.space)
|
| |
| | Part Measurements and Authoring
|
|
A question for all part authors How do you figure out the measurements for your parts? I'm not talking about the obvious measurements such as stud width but the more intricate details on some of the more complex parts. Do you use a micrometer, (...) (22 years ago, 5-Mar-03, to lugnet.cad.dev)
|
| |
| | MOTM/SOTM for February 2003
|
|
Do I ever hate the cold & flu season..... Anyway, here goes; MOTM is Cale Leiphart's "1949 John Deere Model A". This was actually a tough call. Cale's model tied with Carlos un apellido's Supercar model, so I had to be the tie-breaker. The supercar (...) (22 years ago, 5-Mar-03, to lugnet.announce, lugnet.cad, lugnet.cad.dev.org.ldraw)
|
