 | | L3PAO does not work with LGEO
|
|
A little late reaction to this post of 6-9-2002: "travis" <phree@attbi.com> schreef in bericht news:H21DCD.n1L@lugnet.com... (...) I am just (trying) to start using LGEO and have POV 3.5. I have the same problem as Mark and I know the solution from (...) (22 years ago, 27-Nov-02, to lugnet.cad.ray)
|
| |
| | Ldraw Viewer Update
|
|
A quick note, after a delay and vacation, I have posted an update to Ldraw Viewer on my .Mac site. homepage.mac.com/aallan/LdGLite This update gives support with both Classic and Carbon Versions (The Carbon version runs on 10.2.1). New features are (...) (22 years ago, 27-Nov-02, to lugnet.cad.dev.mac)
|
| |
| | Re: Lego Brick Dimensions Changes?
|
|
(...) This is one prime number relationship in the system. If cell spacing is 20 and stud radius is 6, then a diagonal distance between two studs is 20 * Sqrt(2) - 12, or about 16.28. This is the tube outside diameter. The inside diameter ought to (...) (22 years ago, 26-Nov-02, to lugnet.cad)
|
| |
| | Re: A Portable Modeling CD for Holiday Travels?
|
|
Not too much to add except this... drive letters can be used not only for things like CDs but also for subdirectories of existing hard drives. (1) So you could set up a directory like C:\mumble\LDrawCDimage\ then do a NET USE like net use l: (...) (22 years ago, 26-Nov-02, to lugnet.cad)
|
| |
| | Re: Lego Brick Dimensions Changes?
|
|
The LDraw standards for dimensions make up a self-consistent system, though that system has some fundamental differences when compared to real-world bricks. (...) The general rule is that a plate is 1/8th of an inch, so one ldraw unit is 1/64th of (...) (22 years ago, 26-Nov-02, to lugnet.cad)
|
