 | | Re: LDGLite colour bug
|
|
(...) the OSMesa driver on ldraw.org. Its reproducible with just two stud3.dats or even just two 4-4disc4.dats. And it only seems to happen when lighting is enabled and and antialiased edgelines are on, even if you don't have any edgelines. I wonder (...) (23 years ago, 3-Jan-02, to lugnet.cad.dev)
|
| |
| | RE: Ldraw and Ledit in windows xp?
|
|
(...) I get a Run Time Error 200...and the patch seems to have disappeared from ldraw.org. In any case, I can't find a link to it. --Bram Bram Lambrecht bram@cwru.edu www.bldesign.org (23 years ago, 3-Jan-02, to lugnet.cad)
|
| |
| | Re: Can LDGLite print the current orientation matrix? (feature request)
|
|
(...) Probably not. I can run L3Lab under Linux using Wine, but that is on an i686 based computer, not Alpha. Fredrik (23 years ago, 3-Jan-02, to lugnet.cad.dev)
|
| |
| | Re: Proposal: New Parts Category for round parts
|
|
(...) I think this sounds like a sensible approach! (...) You mean something like 2637 Technic Axle 16 with Axleholes 2739 Technic Axle 6 with Ball Joint Sockets I am a bit ambivalent about this. The rods in question are axle shaped, however they (...) (23 years ago, 3-Jan-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: x191 & x192 part in the Parts tracker
|
|
(...) Hallo Carsten, First of all, Best Wishes for the New Year, or should i say : Prosit Neujahr ? 1) Thanks a lot for the info. I will remove the electric wire at the point where it leaves the connector, so that you can't look through the part (...) (23 years ago, 1-Jan-02, to lugnet.cad.dat.parts)
|
