 | | ring5.dat [DAT]
|
|
here is a new ring primitive 0 4 16 5 0 0 4.6195 0 1.9135 5.5433 0 2.2961 6 0 0 4 16 4.6195 0 1.9135 3.5355 0 3.5355 4.2426 0 4.2426 5.5433 0 2.2961 4 16 3.5355 0 3.5355 1.9135 0 4.6195 2.2961 0 5.5433 4.2426 0 4.2426 4 16 1.9135 0 4.6195 0 0 5 0 0 (...) (23 years ago, 9-Jul-01, to lugnet.cad.dat.parts.primitives)
|
| |
| | Re: New Part? - 30117 - Panel 8 x 8 x 2 2/3 [DAT]
|
|
(...) Very nice job, especially if this is your first part! Steve Bliss started this part which eventually became used as a "mock-up". I was supposed to finish it, but several other parts were needed that had a higher priority. The Link for Steve's (...) (23 years ago, 9-Jul-01, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part: x703.dat Wheel Hard-Plastic Fabuland (HELP NEEDED!)
|
|
Amazingly enough, this weekend's activities include fixing the LDL->DAT conversion in LDLite. Check (URL) tommorow for a version 2.2 release. -gyug (...) (23 years ago, 8-Jul-01, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part: x703.dat Wheel Hard-Plastic Fabuland (HELP NEEDED!)
|
|
(...) Two general solutions: 1. LDraw Add-On has an LDL2DAT converter tool, available from both the main window and from the editor. 2. LDLite has a command-line option to produce an LDraw file from an LDLite source. In the current release, this (...) (23 years ago, 8-Jul-01, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part: x703.dat Wheel Hard-Plastic Fabuland (HELP NEEDED!)
|
|
(...) I found it sufficient enough to open in ledit and rotate each of the boxes around the z axis by the desired angle and then you could just delete the coments. One would of caution though is that ledit turns all type 5 lines into type 4 (...) (23 years ago, 8-Jul-01, to lugnet.cad.dat.parts)
|
