 | | Re: L3PAO small update available
|
|
(...) Hmm.. that's odd, because L3PAO should check for POV and still continue even if it isn't found. But then again, I've never tested it on a system that *didn't* have POV installed. Tonight I'll try uninstalling my POV and see if I get the same (...) (24 years ago, 7-Feb-01, to lugnet.cad)
|
| |
| | On the difficulty of making building instructions
|
|
On the difficulty of making building instructions: Last sunday I spent most of the day (except for a few hours out in the snow) showing my cousins how to make - or should I say _draw_ - building instructions on a computer. Personally I use (...) (24 years ago, 7-Feb-01, to lugnet.cad)
|
| |
| | Re: New Part - 3900 Minifig Signal Holder
|
|
(...) The edge lines from the handle extend into the circular panel. This won't look too good if the part is transparent. Plus the angle of entry for the edge lines is narrow so it throws off the edge line offset in ldglite at certain viewing (...) (24 years ago, 7-Feb-01, to lugnet.cad.dat.parts)
|
| |
| | Re: L3PAO small update available
|
|
(...) (24 years ago, 7-Feb-01, to lugnet.cad)
|
| |
| | Re: L3PAO small update available
|
|
Hi Jeff (and others) I have installed all that I (should) need, but L3PAO won't run for me. I have Windows NT 4.0 workstation. I have installed the VB 6.0 files, I have the latest COMDLG32.OCX in my winnt\system32 directory, but when I click (...) (24 years ago, 7-Feb-01, to lugnet.cad)
|
