 | | Re: New Part - 2527 Plate? 2 x 4 cannon base
|
|
(...) Ok, I will fix it and get it re-posted as an updated part. Thank you very much for your input. Paul (URL) (24 years ago, 15-Dec-00, to lugnet.cad.dat.parts)
|
| |
| | pirate's head scarf... well... *sort of*... :-P [DAT]
|
|
OK, this is a really, *really* crude mock-up, I'll be the first to admit, but I really needed something that I could use for this piece, no matter how ugly, as long as it looked *something* like the piece in question, plus there's been one or two (...) (24 years ago, 15-Dec-00, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part - 2527 Plate? 2 x 4 cannon base
|
|
(...) The open end (i.e., the muzzle) should be pointed in the "negative-Z" direction (i.e., pointing "out" of the screen towards the viewer) when shown in a "front" view in MLCAD/L3Lab/[etc.]). Thanks, Franklin (Who has been thinking of creating a (...) (24 years ago, 15-Dec-00, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part - x518 Cannon Pirate
|
|
(...) I will use "Minifig Accessory" as Steve recommended. (...) ok. (...) The cannons I have are the one piece design with the crossed cannon symbol on them. I can do the logo, but it will not look very good rendered. I tried to use as many POV (...) (24 years ago, 15-Dec-00, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part - 2527 Plate? 2 x 4 cannon base
|
|
(...) If it doesn't matter much to anyone, I will rename these parts as Steve stated a few messages back; 2527.DAT Minifig Cannon 2 x 4 Base x518.DAT Minifig Cannon 2 x 8 Non-Shooting ( I measured it, end to end) I will categorize both parts as (...) (24 years ago, 15-Dec-00, to lugnet.cad.dat.parts)
|
