 | | www.ldraw.org working correctly?
|
|
I have just upgraded the web server on www.ldraw.org, so please write me a _short_ note at <sparre-sms@sslug.dk>, if you find some problems with the site/server. Play well, Jacob ---...--- -- E-mail: sparre@cats.nbi.dk -- -- Web...: <URL: (URL) > -- (...) (24 years ago, 23-May-00, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: ldraw.org going down for a kernel upgrade tomorrow
|
|
(...) Done. - I hope nobody noticed it. Play well, Jacob ---...--- -- E-mail: sparre@cats.nbi.dk -- -- Web...: <URL: (URL) > -- ---...--- (24 years ago, 23-May-00, to lugnet.cad.dev.org.ldraw)
|
| |
| | ldraw.org going down for a kernel upgrade tomorrow
|
|
I have some problems using all the swap space I have in my machine, so I have just compiled a new kernel. I will reboot the machine tomorrow morning at approximately 8am Danish time. If I didn't make any misteaks - this is the first time I compile a (...) (24 years ago, 22-May-00, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: looking for torus generator
|
|
(...) It's at (URL). But you might want to look at my rotate.xls utilities instead. This spreadsheet includes a ring-calculator, which gives you the scaling factors needed to construct any ring out of the existing ring-primitives. Well, not any (...) (24 years ago, 22-May-00, to lugnet.cad)
|
| |
| | Re: [Part] 4515p03.dat - Slope Brick 10 6 x 8 with Slate Roof Patt ern [DAT]
|
|
Sorry, the linelength should be OK now. Papp Imre <ipapp@GEOMETRIA.hu> wrote in message news:D148AB3A9D8FD31...D1@MAIL... (...) 0 Slope Brick 10 6 x 8 with Slate Roof Pattern 0 Name: 4515p03.dat 0 Author: James Jessiman 0 Author: Ampi (...) (24 years ago, 22-May-00, to lugnet.cad.dat.parts)
|
