Subject:
|
less messy getting rid of the print on minifigs
|
Newsgroups:
|
lugnet.build.minifigs
|
Date:
|
Fri, 10 Mar 2000 02:17:49 GMT
|
Viewed:
|
1191 times
|
| |
|
|
Hi Everyone,
I have been trying to take off some of the print on some of my minifigs to try
and put my own custom logo on them. i have tried the many ways some people
here on lugnet have suggested and here are the results....
1.X-acto knife- I tried using an x-acto knife on an old fireman torso to get
an all black torso i succesfully removed all of the print but i was
dissapointed to find a bunch of icky streaks where the print used to be so I
didnt use that method anymore.
2. Nail polish remover- I remember someone might have suggested using nail
polish remover to erase some of the print. I took a q-tip and dabbed a little
Nail polish remover on the q-tip so i could take off those things on lukes
belt. i rubbed it on good but it re-settled into a really ugly pattern so I
figured that was worse than the X-acto knife but luckily no streaks :)
Does anyone have any less messy methods to removes the print??
Thanks,
Cj The confused
|
|
Message has 2 Replies:
6 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
