Subject:
|
Re: Amputated Throwbot parts?
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Fri, 2 Jun 2000 18:25:34 GMT
|
Viewed:
|
688 times
|
| |
|
|
In lugnet.build.mecha, Ben Vaughan writes:
> Having just spent the last two and a half hours fighting with the ball
> portion of the ball and socket pieces from the Throwbot set, I'm ready to
> commit heresy and chop one of the balls off. (yes, I know this is a family
> forum. 8) )
>
> The only thing I use these sets for is mecha joints, and I've got a ton of
> them. Anyone else broken down and amputated your Throwbot joints yet?
>
> Ben
>
> Ben Vaughan
> buster@marsbase.com
> http://www.marsbase.com
Yeah, I've tried to cut the throwing arms with little success. The problem
with using throwbot limbs for mechs is that they limit the size of the mech
and creativity in limb design. I wish that TLG would make brick-based
modifications on the pieces- such as a ball with axl fused to the side of a
2x1 brick and a socket fused with a 2x1 brick. I think that would put an end
to everyone having to resort to using the high-friction pin(which is tough to
remove and discontinued anyway) to build cool-looking mecha. That pin issue is
what eventually drove me to use throwbot limbs in my mecha.
|
|
Message is in Reply To:
 | | Amputated Throwbot parts?
|
| Having just spent the last two and a half hours fighting with the ball portion of the ball and socket pieces from the Throwbot set, I'm ready to commit heresy and chop one of the balls off. (yes, I know this is a family forum. 8) ) The only thing I (...) (24 years ago, 2-Jun-00, to lugnet.build.mecha)
|
6 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
