Subject:
|
Re: Help with waist design
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Wed, 15 Mar 2000 03:56:19 GMT
|
Viewed:
|
1053 times
|
| |
|
|
Me, too.
Ben
--
Ben Vaughan
ben@marsbase.com
http://www.marsbase.com
"Sproaticus" <jsproat@io.com> wrote in message
news:38CEAFB4.B60590C1@io.com...
> John Gerlach wrote:
> > In lugnet.build.mecha, Travis Dickinson writes:
> > > Anyways, I have become frustrated with the 4x4 turntable part that I am • using
> > > as the waist.
> > I
> > just looped a rubber band (from an old Technic set!) around the 'base' • piece,
> > so that the 'top' piece sat over it in two spots. The rubber gave some
> > friction between the two pieces, so it wouldn't turn - unless I wanted • it to!
>
> I used pretty much the same approach to tighten the 2x2 turntables -- I • put a
> piece of paper in between the top and the bottom halves.
>
> Cheers,
> - jsproat
>
> --
> Jeremy H. Sproat <jsproat@io.com> ~~~ http://www.io.com/~jsproat/
> Card-carrying member of the Star-Bellied Sneech Preservation Society
|
|
Message is in Reply To:
 | | Re: Help with waist design
|
| (...) I used pretty much the same approach to tighten the 2x2 turntables -- I put a piece of paper in between the top and the bottom halves. Cheers, - jsproat (25 years ago, 14-Mar-00, to lugnet.build.mecha)
|
10 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
