Subject:
|
Re: Tachikoma tank mecha - Ghost in the Shell
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Wed, 19 Apr 2006 14:56:55 GMT
|
Viewed:
|
1690 times
|
| |
|
|
In lugnet.build.mecha, Timothy Gould wrote:
| |
Thanks Anthony,
Amusingly enough the original design was exactly as you described (studs out
version) but it looked a bit bug-eyed so I moved the eyes on top. Thanks
anyway.
Tim
|
Ok, one more idea and then I’ll leave you alone.
What if you removed the parts above the 4x4 round brick you have there now, and
instead attached three of these to it, lined up above where the technic holes of
the 4x4 round brick.
Then, put a few more plates on the 4x4 round brick to act as an anchor, and then
attach a 4x4 blue radar dish on top to give the head the dome look.
Next, attach one of these to each of the 1x2 plates pictured above:
So that they lay over the top of the radar dish. Then just attach the white 1x1
round plates to that.
Not sure how good that’ll look, but it might be worth a shot.
--Anthony
|
|
Message has 1 Reply:
 | | Re: Tachikoma tank mecha - Ghost in the Shell
|
| (...) Please keep them coming. I'm stumped. --SNIP-- (...) I tried it and it would look great except that the parts can't rotate enough :( They end up about 10 degrees from vertical. A real shame since if it could rotate more it would be great. (...) (18 years ago, 19-Apr-06, to lugnet.build.mecha, FTX)
|
Message is in Reply To:
13 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
