Subject:
|
Worm Gear Problem
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Wed, 21 Dec 2005 02:54:16 GMT
|
Viewed:
|
1500 times
|
| |
|
|
Would someone care to tell me how to take the slack out of wormgear joints? I
love their strenth but hate the wobble. Anything you can give me would be
appreciated. Thanks.
-Brayton
|
|
Message has 2 Replies:
 | | Re: Worm Gear Problem
|
| (...) The backlash (spacing between the teeth of a gear and the splines on the worm gear) is difficult to over come. There are some techniques to reduce the effect. 1. Use Technic Throwbot Gear Boxes and use a z40 in the set up. 2. Use a compund (...) (19 years ago, 21-Dec-05, to lugnet.build.mecha, FTX)
| | | Re: Worm Gear Problem
|
| Hi Brayton, While erics reply is pretty comprehensive, have you posted to .technic to see what they have there? Warning - I am about to databurst again... I can see what eric says about the counter system - and I wander if if could be simply (...) (19 years ago, 22-Dec-05, to lugnet.build.mecha)
|
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
