Subject:
|
Re: Technic Tread links
|
Newsgroups:
|
lugnet.build
|
Date:
|
Sun, 11 Jul 1999 05:09:04 GMT
|
Viewed:
|
556 times
|
| |
|
|
I bought that set of tread links recently.
N779938 - 36 x Conveyor belt links - $6.25
Actually I received 40 links! But I still think that's way expensive...
I had enough to make a tread using 2 24-tooth gears spaced 12 holes apart
(including the two holes used by the gears)
There was one link left.
Needless to say, I do not have enough to test the 23pip spacing scenario.
-Hari-
Mike Case wrote in message <3787f226.1468194@lugnet.com>...
> I've been looking at the technic tread links available from Pitsco and
> have one question about them. How many links does it take to make a
> decent set of treads? For example, how many links are used to make a
> tread with 24-tooth gears at the ends and spaced 15pips from axle to
> axle? with 40-tooth gears and a 23 pip spacing?
|
|
Message has 1 Reply:
 | | Re: Technic Tread links
|
| Hello Have you checked the 856 bulldozer? this one uses 40 tooth gears, and are 14 holes appart, axle holes included. This one uses 50 peaces per tread. The 8851 uses even more, but this tread also goes over two 16 tooth gears. You can check the (...) (25 years ago, 11-Jul-99, to lugnet.build)
|
Message is in Reply To:
| | Technic Tread links
|
| I've been looking at the technic tread links available from Pitsco and have one question about them. How many links does it take to make a decent set of treads? For example, how many links are used to make a tread with 24-tooth gears at the ends and (...) (25 years ago, 11-Jul-99, to lugnet.build)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
