| |
Anyone know if the New boat motor in or can
be attached to the botton of, and provide enough ballast to, the old boats like
that use the ballast weight to replace the ballast weight?
I was thinking it could be attached with a couple of the 2x2 plate with holes
 a couple of friction pins with axle
Anyone have one to try this with?
-Rob A>
|
|
Message has 1 Reply:
 | | Re: Boat Motor
|
| (...) I don't know if that will work. I'm not sure if a single 2x2 set of dots will stick to the hull given than the motor is pushing an inch down from where that piece is. Of course, the motor doesn't put out a lot of force, but it might not stick (...) (20 years ago, 24-Jan-05, to lugnet.boats, lugnet.org.ca.rtltoronto, FTX)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
