 | | Re: make.exe
|
|
Thanks for the reply, I'll redo QC.h and the demo programs. John A. Donaldson (...) (24 years ago, 23-Jan-00, to lugnet.robotics)
|
| |
| | Re: BRICKS going offline soon, probably for good
|
|
Well I'll miss it Mike, being one of the regular buyers from Julie and Dwayne Mark H. (...) (24 years ago, 23-Jan-00, to lugnet.market.auction)
|
| |
| | Re: legOS for Windows Finished!
|
|
(...) I will send them to you via E-Mail. I've patched and tested them both and recently posted the diffs file on lugnet.robotics.rcx.legos, but I have not received any feedback (for firmdl3) at all. :-( I've also wrote to Peter Van Beken and kekoa (...) (24 years ago, 23-Jan-00, to lugnet.robotics.rcx.legos)
|
| |
| | #5120 Polarity Switch: cheap shaft encoder/rotation sensor?
|
|
If you remove the lever from the polarity switch you can insert an axle through the switch which will cycle the switch continuously between fwd/off/rev/off. Since most of the tension in the switch is actually provided by the lever slot, this axle (...) (24 years ago, 23-Jan-00, to lugnet.robotics)
|
| |
| | Re: Michael Collins....Are you there?
|
|
Hi Larry, I haven't had any trouble getting through to them using the following email address: r.collins2@dtn.ntl.com Mark H. (...) (24 years ago, 23-Jan-00, to lugnet.general, lugnet.market.buy-sell-trade)
|
| |
| | Re: Technic Pin Adaptor
|
|
Sorry I don't understand. This seems a cluster of pegholes rather than a part. Most of the parts posted by you dated 24/1(!) are not even in one piece. But then gain, I've never seen the parts in question IRL... /Tore (...) (24 years ago, 23-Jan-00, to lugnet.cad.dat.parts)
|
| |
| | Re: Need some information
|
|
The small ones are still readily available in Australia, but the big sets sold out before Xmas. Mark H. (...) (24 years ago, 23-Jan-00, to lugnet.market.buy-sell-trade)
|
| |
| | Re: 2000 lego in oz?
|
|
All service packs are being discontinued. Mark H. (...) (24 years ago, 23-Jan-00, to lugnet.loc.au.wa.per)
|
| |
| | Re: Cannons
|
|
Frank Filz wrote in message <388747F6.2C67@minds...ng.com>... (...) 1989 in the U.S.: Shooting cannons 1990: "disabled" shooting cannons 1991: the first solid-cannons I have a 6270 (1989) set with solid cannons, but it was purchased later than '90. (...) (24 years ago, 23-Jan-00, to lugnet.general)
|
| |
| | Quite C - Re: Make file
|
|
You can compile files by hand using info into makefile -- ___...___ Ferrara Francesco John A. Donaldson <lego-robotics@crynwr.com> wrote in message news:3889046A.3F12BC...nfi.net... (...) (24 years ago, 23-Jan-00, to lugnet.robotics)
|
