| | Re: Building Bridges
|
|
(...) A lift bridge or a draw bridge? (...) Why would you use mindstorms to control the bridge except perhaps as a aproach sensor? It's easier to do that with manual blocks, than with electronics. Although, I suppose you could get it to work fine. (...) (25 years ago, 26-Nov-99, to lugnet.trains)
|
|
| | Re: Scout vs RIS and reverse engineering and Byte Codes
|
|
No, it's in ROM memory (like the Cybermaster). CU Bert Lego robots and artificial intelligence www.bvandam.net -----Oorspronkelijk bericht----- Van: Mike Kory <kory@advancenet.net> Aan: lego-robotics@crynwr.com <lego-robotics@crynwr.com> Datum: (...) (25 years ago, 26-Nov-99, to lugnet.robotics)
|
|
| | RE: Scout vs RIS and reverse engineering and Byte Codes
|
|
(...) I'm just guessing. If it has the upload data opcode, why not unlock firmware? On the RCX, there needed to be a specical code "Do you byte...etc" to allow the firmware to be "unlocked" and executed from 0x8000 hex. Now, the trick was to monitor (...) (25 years ago, 26-Nov-99, to lugnet.robotics)
|
|
| | New newsgroup for for LeoCAD
|
|
A new group dedicated to LeoCAD has just been created. LeoCAD is a free program written by Leonardo Zide for modeling LEGO designs (or other construction systems). CHARTER/PURPOSE ===...=== lugnet.cad (group and hierarchy): Discussions of CAD (...) (25 years ago, 26-Nov-99, to lugnet.announce, lugnet.admin.general, lugnet.cad, lugnet.cad.dev, lugnet.cad.leocad)
|
|
| | Re: Linux Magazine Article
|
|
(...) It's already in a very good stage, it can do all of the basic editing commands (only a few dialog boxes and the printing routines are missing). It's located at (URL) I'm *almost* sure I mentioned that here... :) Leonardo PS: Todd, could you (...) (25 years ago, 26-Nov-99, to lugnet.cad.dev)
|