 | | Re: Compass sensor with NXC
|
|
(...) I emailed Karen with the solution to her problem. This can trip you up if you aren't careful. Drawing values to the screen can confuse you if you draw over the top of an existing number without clearing the screen first. John Hansen (17 years ago, 29-Feb-08, to lugnet.robotics.nxt)
|
| |
| | Re: L3Lab for Mac
|
|
(...) Thanks! (...) Yes, I just realized I have misunderstood the Selected state in HIToolbar - only one item can be selected at any time, so I cannot use it for showing the state of the many toggles in the toolbar. Guess I'll have to change the (...) (17 years ago, 29-Feb-08, to lugnet.cad.dev.mac)
|
| |
| | Re: L3Lab for Mac
|
|
(...) Case shouldn't matter on the Mac. I don't check for P and PARTS. The prompt ("LDrawDir '%s' is not a valid directory", Path) comes if (stat(Path, &Stat) == 0 && (Stat.st_mode & S_IFDIR)) fails. So please check again... and remove the trailing (...) (17 years ago, 29-Feb-08, to lugnet.cad.dev.mac)
|
| |
| | Re: L3Lab for Mac
|
|
(...) You might check the P and PARTS directories. I switched them to lower case in the plist. I didn't try with them upper case, so I don't know if that would have worked or not. I know the error message is complaining about the main LDraw (...) (17 years ago, 29-Feb-08, to lugnet.cad.dev.mac)
|
| |
| | Re: L3Lab for Mac
|
|
(...) I double checked and I mistyped the error above. The error displays a leading slash, and so does the config file. /Users/Tim/Applicati...ith/LDraw/ is a valid directory. I added a trailing slash after LDraw/ for gits and shiggles, doesn't work (...) (17 years ago, 29-Feb-08, to lugnet.cad.dev.mac)
|
