| | Re: Base plate thickness?
|
|
(...) 0.055 inch would be correct. It never crossed my mind that 0.5 = 1/2. I don't use my calipers often enough to correctly interpret its output every time I do. Lesson learned: Double, uh, no, triple-check the readout (and make shure I'm (...) (17 years ago, 5-Feb-08, to lugnet.general)
|
|
| | Re: Which CAD program recommended for Mac??
|
|
(...) Yes, this is very annoying as using the arrow keys to move a part/assembly all the way across the model can be slow and painful, especially since Bricksmith doesn't seem to display cursor coordinates. (...) Ok, I see. I'd like functionality to (...) (17 years ago, 4-Feb-08, to lugnet.cad, lugnet.cad.dev.mac)
|
|
| | Re: Base plate thickness?
|
|
(...) Scott, I'm sorry; That can't be right. More than half an inch? Did you mean 0.055 inch? I'm talking about the thickness of a baseplate, the area without the studs, the distance a block would be above my desk if the block were sitting on a (...) (17 years ago, 4-Feb-08, to lugnet.general)
|
|
| | Re: Power Functions infra-red RC protocol released!
|
|
(...) rats! (...) Thanks for the heads up, John Looks like I really have to start brushing up on my NXT 'bot building now. Dave K (17 years ago, 4-Feb-08, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics)
|
|
| | Re: Base plate thickness?
|
|
(...) 0.55 inch. That's measuring with a dial calipers. HTH sjf (17 years ago, 4-Feb-08, to lugnet.general)
|