To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
To LUGNET News Traffic PageSign In (Members)
  *558059 (-5)
  Re: Lego artist needed
 
(...) Hi the pro builders are a good lot, Nathan does custom work (called the brick artist), you can also check with the clubs, some of them do amazing work as well. www.brickmuseum.net Dan (17 years ago, 26-Jan-08, to lugnet.events, lugnet.admin.general, lugnet.build.arch, lugnet.build.sculpture, lugnet.general, lugnet.loc.us, lugnet.loc.us.fl, lugnet.loc.us.fl.orl)
 
  Re: Power Function control with RCX and BrickOS
 
(...) Okay, thanks. I can get 'Single output Mode' to work now. 'Single pin Mode' may be working too, but I'm not sure what to expect from it. I would expect setting either C1 or C2 would set them to 9V and run a motor forwards or backwards. Setting (...) (17 years ago, 26-Jan-08, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics, FTX)
 
  Re: Wrong Head?
 
(...) I received my replacement today along with what appears to be a canned letter. --Jack AFOL, St. Louis (17 years ago, 26-Jan-08, to lugnet.adventurers, FTX)
 
  Re: Power Functions infra-red RC protocol released!
 
(...) I'd be very interested in that experiment (using a Hobby train RC on the PW Receiver) as well, but this does answer a number of questions for trains. For instance, tunnels and large layout out of line-of-sight on the RC should now be possible. (...) (17 years ago, 26-Jan-08, to lugnet.technic, lugnet.trains, lugnet.robotics)
 
  Re: Power Functions infra-red RC protocol released!
 
(...) Either single pin modes allow to set each output to 1 (9V) or 0 (0V). (...) See the drive datasheet: (URL) can reach 1A peak, continuous value is lower (500-600mA) especially if both outputs are heavily loaded at the same time. Philo (17 years ago, 26-Jan-08, to lugnet.technic, lugnet.trains, lugnet.robotics)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR