|
|
 | | Re: Power Functions infra-red RC protocol released!
|
| (...) I'd be very interested in that experiment (using a Hobby train RC on the PW Receiver) as well, but this does answer a number of questions for trains. For instance, tunnels and large layout out of line-of-sight on the RC should now be possible. (...) (17 years ago, 26-Jan-08, to lugnet.technic, lugnet.trains, lugnet.robotics)
| | | | | Re: Power Functions infra-red RC protocol released!
|
| (...) Either single pin modes allow to set each output to 1 (9V) or 0 (0V). (...) See the drive datasheet: (URL) can reach 1A peak, continuous value is lower (500-600mA) especially if both outputs are heavily loaded at the same time. Philo (17 years ago, 26-Jan-08, to lugnet.technic, lugnet.trains, lugnet.robotics)
| | | | | Re: Power Function control with RCX and BrickOS
|
| (...) Bob, I could not wait to get home from work to try this. I want to say thank you; your effort has saved me many countless hours. I loaded the Firmware, and the Program into a 1.0 RCX, and the brick worked flawlessly! On my 1.0 brick, I was (...) (17 years ago, 26-Jan-08, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics)
| | | | | Re: "Studless" hinges?
|
| Ohhhhh, so that's what that program is for... Thanks, Philo, that does the trick. (17 years ago, 26-Jan-08, to lugnet.cad)
| | | | | Re: Norfolk & Western Y6b 2-8-8-2 Steam Locomotive
|
| (...) Cale: That is one sweet looking loco. :-) I happen to be a fan of the jagged boiler look. It gives it that strong, tough, and rough around the edges look. Very nice. I agree with Tony that 9-wide just sets this thing off. It really puts it in (...) (17 years ago, 26-Jan-08, to lugnet.trains, FTX)
|
|
