 | | RE: HELP! NXT brick flash now read-only!!
|
|
(...) It may be obvious, but: Holding the reset pin for a few seconds simply does a brick reset. Holding the reset pin for around 15 seconds is supposed to put the brick into SAMBA mode. You are doing the second I hope. And just to be safe, you've (...) (19 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
|
| |
| | Re: HELP! NXT brick flash now read-only!!
|
|
(...) OK, everybody take a deep breath and slow down. first of all, the SAMBA version I'm using is 1.11, available here: (URL) And for anyone that's going to get busy hacking firmware, this is a great place to start: (URL) Yes, there is a script (...) (19 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
|
| |
| | Legofest di Ballabio: aggiornamenti
|
|
A breve saranno disposibili sul sito due nuove pagine: una riguarda il pernottamento e una riguarda i responsabili dei diorami. Per quanto riguarda quest'ultima se manca qualcosa, c'è qualcosa di troppo o devo aggiungere altre informazioni fatemi (...) (19 years ago, 4-Feb-07, to lugnet.org.it.itlug)
|
| |
| | Re: HELP! NXT brick flash now read-only!!
|
|
(...) The Atmel SAM-BA downloader, included in their In-system Programmer package: (URL) was using an older version than the one currently available on their site, though (1.7 vs. 1.8). (...) Well, it would be nice to be able to get back IN to the (...) (19 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
|
| |
| | Re: HELP! NXT brick flash now read-only!!
|
|
(...) Nathan, What software did you use to load V1.04? It sounds like there is something in there that set the firmware to read-only after it loaded it. Can you find any settings like that in that software? Steve (19 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
|
